하드웨어/Network 장비2017. 4. 26. 08:14

USB OTG는 5핀으로 작동하고

USB의 Vcc , GND 와 D+ D-에 추가로 ID 라인이 추가된다.

그래서 micro USB type B는 4핀이 아니라 5핀인데...


OTG를 위해서는 10k 저항을 이용해서 장치가 host mode 인지 peripheral mode 인지 체크를 하고

내부 프로토콜에 의해서 서로 host와 peripheral을 정해서(드라이버 내장 유무 문제로) 통신을 한다고 한다.


Sounds like you've got a host problem. USB OTG if I remember correctly tried to negotiate electrically through pull-up / pull-down resistors who's gonna'be host and who's gonna be slave when establishing the initial USB handshake. Might be that one of those pull resistors is fried? 

[링크 : http://www.xoomforums.com/forum/jelly-bean-general-discussion/18801-otg-cable-not-working.html]


망할(!) 노트2는 usb 5 + mhl 6으로 총 11핀 짜리라서 더 문제가 심한듯..

근데 충전이 안된다는건 내부 풀업등의 문제로 충전전류 선택이 안된다는 걸테니..

이것은 매우 흔한 증상으로 휴대폰의 충전단자와 usb를 교체하면 해결된다 들음  

[링크 : http://www.oeker.net/bbs/board.php?bo_table=it&wr_id=298113]



[링크 : https://electronics.stackexchange../why-does-micro-usb-2-0-have-5-pins-when-the-a-type-only-has-4]

[링크 : https://www.maximintegrated.com/en/app-notes/index.mvp/id/1822]

'하드웨어 > Network 장비' 카테고리의 다른 글

tftp를 이용한 iptime 벽돌 복구  (0) 2018.05.14
랜카드 티밍관련 조사...  (0) 2017.11.29
iptime 전원 어댑터관련...  (0) 2016.11.04
망할 iptime 외부접속 보안 설정  (0) 2016.11.03
z-wave  (0) 2015.09.10
Posted by 구차니