구차니의 잡동사니 모음

[  705.076085] usb 1-6: new high-speed USB device number 3 using ehci-pci

[  705.208918] usb 1-6: New USB device found, idVendor=152d, idProduct=2339

[  705.208931] usb 1-6: New USB device strings: Mfr=1, Product=2, SerialNumber=5

[  705.208938] usb 1-6: Product: USB to ATA/ATAPI Bridge

[  705.208943] usb 1-6: Manufacturer: JMicron

[  705.208948] usb 1-6: SerialNumber: 1E34FFFFFFFF

[  705.283199] usb-storage 1-6:1.0: USB Mass Storage device detected

[  705.283484] scsi8 : usb-storage 1-6:1.0

[  705.283768] usbcore: registered new interface driver usb-storage

[  705.313829] usbcore: registered new interface driver uas

[    2.990457] scsi 6:0:0:0: Direct-Access     WDC WD40EZRX-00SPEB0          PQ: 0 ANSI: 2 CCS

[    2.991789] sd 6:0:0:0: Attached scsi generic sg1 type 0

[    2.992179] sd 6:0:0:0: [sdb] 3519069872 512-byte logical blocks: (1.80 TB/1.63 TiB)

[    2.993272] sd 6:0:0:0: [sdb] Write Protect is off

[    2.993281] sd 6:0:0:0: [sdb] Mode Sense: 00 38 00 00

[    2.994269] sd 6:0:0:0: [sdb] Asking for cache data failed

[    2.994278] sd 6:0:0:0: [sdb] Assuming drive cache: write through

[    3.031761]  sdb: unknown partition table

[    3.035276] sd 6:0:0:0: [sdb] Attached SCSI disk 

$ sudo fdisk -l

Disk /dev/sda: 320.1 GB, 320072933376 bytes

255 heads, 63 sectors/track, 38913 cylinders, total 625142448 sectors

Units = sectors of 1 * 512 = 512 bytes

Sector size (logical/physical): 512 bytes / 512 bytes

I/O size (minimum/optimal): 512 bytes / 512 bytes

Disk identifier: 0x000ac755

   Device Boot      Start         End      Blocks   Id  System

/dev/sda1   *        2048   621012991   310505472   83  Linux

/dev/sda2       621015038   625141759     2063361    5  Extended

/dev/sda5       621015040   625141759     2063360   82  Linux swap / Solaris

WARNING: GPT (GUID Partition Table) detected on '/dev/sdb'! The util fdisk doesn't support GPT. Use GNU Parted.

Disk /dev/sdb: 1801.8 GB, 1801763774464 bytes

256 heads, 63 sectors/track, 218196 cylinders, total 3519069872 sectors

Units = sectors of 1 * 512 = 512 bytes

Sector size (logical/physical): 512 bytes / 512 bytes

I/O size (minimum/optimal): 512 bytes / 512 bytes

Disk identifier: 0x00000000

   Device Boot      Start         End      Blocks   Id  System

/dev/sdb1               1  4294967295  2147483647+  ee  GPT 

$ sudo parted /dev/sda print

Model: ATA WDC WD3200BEVT-0 (scsi)

Disk /dev/sda: 320GB

Sector size (logical/physical): 512B/512B

Partition Table: msdos

Number  Start   End    Size    Type      File system     Flags

 1      1049kB  318GB  318GB   primary   ext4            boot

 2      318GB   320GB  2113MB  extended

 5      318GB   320GB  2113MB  logical   linux-swap(v1)

$ sudo parted /dev/sdb print

Error: 부적절한 인수 during seek for read on /dev/sdb 

[    2.466401] scsi 3:0:0:0: Direct-Access     ATA      WDC WD40EZRX-00S 0A80 PQ: 0 ANSI: 5

[    2.466705] sd 3:0:0:0: [sdb] 7814037168 512-byte logical blocks: (4.00 TB/3.63 TiB)

[    2.466709] sd 3:0:0:0: [sdb] 4096-byte physical blocks

[    2.466723] sd 3:0:0:0: Attached scsi generic sg1 type 0

[    2.466764] sd 3:0:0:0: [sdb] Write Protect is off

[    2.466767] sd 3:0:0:0: [sdb] Mode Sense: 00 3a 00 00

[    2.466792] sd 3:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA

[    2.560959]  sdb: sdb1 sdb2

[    2.561389] sd 3:0:0:0: [sdb] Attached SCSI disk 

[  705.076085] usb 1-6: new high-speed USB device number 3 using ehci-pci

[  705.208918] usb 1-6: New USB device found, idVendor=152d, idProduct=2339

[  705.208931] usb 1-6: New USB device strings: Mfr=1, Product=2, SerialNumber=5

[  705.208938] usb 1-6: Product: USB to ATA/ATAPI Bridge

[  705.208943] usb 1-6: Manufacturer: JMicron

[  705.208948] usb 1-6: SerialNumber: 1E34FFFFFFFF

[  705.283199] usb-storage 1-6:1.0: USB Mass Storage device detected

[  705.283484] scsi8 : usb-storage 1-6:1.0

[  705.283768] usbcore: registered new interface driver usb-storage

[  705.313829] usbcore: registered new interface driver uas

[  706.280751] scsi 8:0:0:0: Direct-Access     ST2000DM 001-1CH164            PQ: 0 ANSI: 2 CCS

[  706.281609] sd 8:0:0:0: Attached scsi generic sg2 type 0

[  706.289238] sd 8:0:0:0: [sdc] 3907029168 512-byte logical blocks: (2.00 TB/1.81 TiB)

[  706.289961] sd 8:0:0:0: [sdc] Write Protect is off

[  706.289971] sd 8:0:0:0: [sdc] Mode Sense: 00 38 00 00

[  706.290594] sd 8:0:0:0: [sdc] Asking for cache data failed

[  706.290604] sd 8:0:0:0: [sdc] Assuming drive cache: write through

[  706.322024]  sdc: sdc1

[  706.325373] sd 8:0:0:0: [sdc] Attached SCSI disk 

[KT IPTV 지원 제품 리스트(펌웨어 Ver. 9.20 기준)]

- 유무선 공유기

A5004NS / A3004NS / A2004 / A2004NS / A2004plus / A2004NSplus / A604 / A604V / A104 / A104NS /

N8004R / N8004V / N6004R /  N904plus / N904Vplus / N904 / N904V / N804T3 / N804A3 /

N604Tplus / N604T /N904NS / N704NS / N704BCM / N704-V3 / N704-A3 / N604S /

N604A / N104S-r1 

- 유선 공유기

X6003/T3004 / T3008(지정포트 LAN 8포트) 

[IPTV 지원 불가 제품 리스트]

N104T / N104-r3 / N5-r1 / WE-R1 / mini

[링크 : http://www.iptime.co.kr/~iptime/bbs/view.php?id=faq_setup&no=587] 

# opengalax configuration file

#### config data:

serial_device=/dev/serio_raw0

uinput_device=/dev/uinput

rightclick_enable=1

rightclick_duration=350

rightclick_range=10

# direction: 0 = normal, 1 = invert X, 2 = invert Y, 4 = swap X with Y

direction=4

# set psmouse=1 if you have a mouse connected into the same port

# this usually requires i8042.nomux=1 and i8042.reset kernel parameters

psmouse=0

#### calibration data:

# - values should range from 0 to 2047

# - right/bottom must be bigger than left/top

# left edge value:

xmin=0

# right edge value:

xmax=2047

# top edge value:

ymin=0

# bottom edge value:

ymax=2047

opengalax v0.4

Configuration data:

        serial_device=/dev/serio_raw0

        uinput_device=/dev/uinput

        rightclick_enable=1

        rightclick_duration=350

        rightclick_range=10

        direction=4

        psmouse=0

Calibration data:

        xmin=0

        xmax=2047

        ymin=0

        ymax=2047

pannel initialized

Move the mouse around the screen to calibrate.

When done click Ctrl+C to exit.

Remember to edit /etc/opengalax.conf and save your calibration values

     xmin=206  xmax=2119  ymin=143  ymax=1951

# opengalax configuration file

#### config data:

serial_device=/dev/serio_raw0

uinput_device=/dev/uinput

rightclick_enable=1

rightclick_duration=350

rightclick_range=10

# direction: 0 = normal, 1 = invert X, 2 = invert Y, 4 = swap X with Y

direction=4

# set psmouse=1 if you have a mouse connected into the same port

# this usually requires i8042.nomux=1 and i8042.reset kernel parameters

psmouse=0

#### calibration data:

# - values should range from 0 to 2047

# - right/bottom must be bigger than left/top

# left edge value:

xmin=206

# right edge value:

xmax=2119

# top edge value:

ymin=143

# bottom edge value:

ymax=1951